How To Make A Bow & Arrow

August 5, 2011 1:38 pm 2 comments

Share this Article



Once the weapon of choice for everyone from Native Americans to Turkish armies, the bow is one of the oldest hunting (and fighting) tools on Earth . While it is not a match for modern weaponry — or indeed for modern archery equipment — a primitive bow can still save your life if you have to hunt to survive in the wilderness.

A high quality bow can take weeks or months to cure and construct, but a simpler version (1.0)can be made relatively quickly and with readily available materials. The instructions below, based largely on the U.S. Army Survival Manual FM 21-76, can teach you how to construct a “field-expedient” bow.



1) Choose a piece of wood for the bow or stick.

This piece of wood should be flexible, such as juniper or mulberry.You can even use a shaft of bamboo or cane but take care that it is not too thick.For that you can use a young bamboo which is strong as well as flexible. Find a piece of dry, dead but not gray and cracking hardwood–oak, lemon tree wood, hickory, yew, black locust, or teak for example–about 1 meter (1 yard +/-) in length. The wood should be free of knots, twists or limbs.

Green wood can be used if absolutely necessary, but it should be avoided because it does not provide the same power as dry wood. If using green wood, try for pine. It is the easiest to cut, and clean. Steel wool is usable to clean it off. Also if using green wood, skin it and soak it in hot water. This will help the bow to bend. If it is green wood once you bend it you can smoke it over a fire to dry it; just don’t hold it so close that it burns. Also try to get one that curves enough, so that when you release arrows, the string doesn’t slap the side of your hand which is very painful.

2) Determine the natural curve of the stick.

Every piece of wood will have a natural curve, no matter how slight. As you construct the bow, be mindful of the curve.

3) Shape the Bow

Ideally, you will want the bow to be strong (and hence thicker) in the center. A thick center will also serve as a good handle. Using a knife or similar tool, shave wood off the inside of the curve (the side that faces behind you when shooting) on the thicker half of the stick until it has the same width and pull as the thinner half. If the stick is roughly the same diameter all along its length, you may need to shave both ends to some degree. You want the bow to end up with a thick, strong center portion flanked by two thinner, more flexible end segments of roughly the same thickness and length (see Figure below).

4) Cut notches to hold the bow string

Use your knife to cut notches about 1-2 inches from each end of the bow. The notches should be in the shape of a half moon on the outside of the bow’s curve

5) Select a Bow string

The string can be made of rawhide, thin nylon rope, hemp cord, fishing line, strands of cotton or silk from caterpillars, perhaps even vines or sinew. If you are stranded in the wilderness, it may be difficult to find a suitable string, and you may need to try a variety of materials before you find one that has the necessary strength. The string should not be stretchy, as the power comes from the wood, not the string.Some ordinary twine will do fine.


1) Select sticks for arrows

Some strong, straight plants for arrows are goldenrod and mullen. They can be found in fields. Arrows should be formed from the straightest sticks you can find. The wood should be dry and dead, however green wood does work if you can give it some extra time to dry out naturally, as the sap may ignite if placed over a fire to dry; each arrow should be about half as long as the bow, or as long at the bow can draw back. It does not work to have arrows that can’t be pulled back to the bow’s potential.

2) Shape the arrows

You will need to whittle the wood smooth around the circumference of the arrow. You can straighten an arrow by gently heating the shaft over hot coals–do not scorch or burn the wood–and then holding the arrow straight while the wood cools. Carve a small notch at the back end of each arrow to accommodate the bow string.

3) Construct the arrowheads

The simplest arrowhead is simply a carved point on the front of the arrow shaft. You can whittle such a point with a knife and then fire harden it by gently heating it in coals (again, be careful not to burn or scorch the wood). You can also construct an arrowhead from metal, stone, glass, or bone and attach it to the arrow’s tip by notching the wood, inserting the arrowhead into the notch, and then lashing the arrowhead to the wood with some sort of string or cord.

4) Find some feathers to make the fletchings and glue them (if possible) onto the back ends of the arrows

You could also split back of the arrow, slide the feather in, and tightly wrap a thin thread ( possibly obtained from your own clothes)around the fletching. If a fletching is not feasible, skip this step. While fletching improves the arrow’s flight, it is not necessary for a field-expedient weapon.


  • To make a fire using the bow you will need to gather dry moss, dryer lint, or other suitable tinder, a piece of hard wood that fits into your palm, and a piece of soft wood (softer than your arrow shaft).Cut a nock in the soft wood approximately 3 centimetres deep running the thickness of the wood, place this nock directly upon the tinder. Drill a small hole into the hard, palm-sized wood slightly larger than the diameter of your arrow shaft and no deeper than 5-10 millimetres. Twist a de-headed arrow into the string of the bow and place the butt of the arrow into the hole drilled into the hard wood. CAREFUL, as the arrow will want to twist out of the string and may injure you. Place the tip of the arrow into the nock of the soft wood. Begin pulling the bow back and forth, keeping the motion steady and even. The soft wood will begin to heat, smoke, and will eventually produce a small ember. This ember should fall into your pile of tinder. If carefully nursed, and blown upon until small flames appear, the pile can be picked up and carried by the bottom, carefully, and quickly to a prepared fire site.
  • If you plan to fish with your bow, make sure to aim slightly below the fish due to the angle of refraction from the water. Fletching is also not needed if you plan to fish with your bow.
  • The bow and arrow detailed here is meant to be temporary and will not have a long life. Fortunately, you can relatively easily construct a replacement.
  • The U.S. Army Survival Manual FM 21-76, a public-domain resource, provides instructions for a variety of tools and weapons, and is a goldmine of survival tips. You can easily find a used copy online or in military surplus stores, and it can be purchased as a slightly changed reprint at some bookstores. The entire manual is also available free of charge in PDF format on the website for the Equipped to Survive Foundation (see External Links below).
  • You can increase the bow’s power by making two identical bows and lashing them together front-to-front (so that they form an “X” when viewed from the side) with string or rope. They should be tied together at the tips. Attach the bow string to only one of the bows. This is sort of a primitive crossbow.
  • Additional Tip: Tightly wrap the bow with a wet strip of leather around the center two thirds of the bow (before stringing) and let it dry naturally. This will give your bow extra strength to resist breakage and should allow you to project arrows at a greater velocity.
  • You can carve a notch about a centimeter into the wood and an inch up to put your arrows on once your bow is pulled back(to rest the arrow on, and keep it from wobbling).
  • When you are testing a bow’s draw weight, do not dry fire, or let go of the bowstring without an arrow on it. This will damage the bow over time.
  • When making arrows, it is not necessary to fletch them, simply cut thin shavings off the wood, and leave them attached at one end, when bent up, these should act as make-shift and easy to construct flights. Do not let them run across your hand, follow the above tip to avoid that problem.


  • When shaping the bow, make sure to shave wood off the inside of the curve (the belly of the bow). Otherwise, the bow is likely to break on its first use.
  • The bow and arrow is not easy to use effectively. If you find yourself in a situation where you need to hunt to survive, you may be better off constructing traps or a more easily-used weapon.
  • This bow and arrow is a lethal weapon. Exercise caution when using, and never aim at anything you do not intend to kill.
  • Use extreme caution with the knife or axe.
  • You may want to carry a bowstring with you when camping as they are hard to make from scratch.
  • Keep bow and arrows out of reach of small children.
  • Always wait for everyone to finish shooting to collect arrows.
  • If you cut the arrow too short and you pull the bow back it can go through your hand.

Things You’ll Need

  • A Hardwood Stick; About 1 Meter In Length (For The Bow)
  • Non-Stretchy String (Weed eater line, 50 pound fishing line, etc.)
  • Wood-Cutting Tool (Knife Or An Axe)
  • Straight, Dead Sticks; About 1/2 Meter In Length (For Arrows)
  • Feathers (For Fletching)
  • Flint Stone; Metal; Similar Materials for Making Arrowheads
  • Steel Wool (If Making A Green Bow)
  • Skill
  • Swiss Army knife (Very useful for almost everything)




Leave a Reply

Other News

  • Food & Drink Quickly chill any drink in minutes!

    Quickly chill any drink in minutes!

    Bought a beautiful 6 pack after a long day, only to get home and find they’re room temperature? You then have that moral quandary - do you put in the fridge/freezer for an hour, or do you drink a warm beer? Let us help. Simply wrap the beer in a wet paper towel, and place in the freezer. Special physical magic takes place, and the beer should ice cold in less than 15 minutes!

    Read more →
  • Food & Drink Instant ice cold water!

    Instant ice cold water!

    Like to take water with you on your daily run, or on a hot day? Cold tap water doesn’t stay cold for long, and ice takes an unusually long amount of time to melt. Get the best of both worlds, without faffing around with ice cubes, using this life trick: Simply fill your exercise/water bottle up to the quarter mark. Place on it’s side in the freezer, whilst ensuring the water level doesn’t cover the mouthpiece. When you want cold [...]

    Read more →
  • Food & Drink How to tell if an egg is fresh

    How to tell if an egg is fresh

    Eggs – the little bundles of joy/salmonella. Use this simple guide to help you determine whether the egg is fresh – all you need is some water.

    Read more →
  • DIY Home painting made easier

    Home painting made easier

    Painting something at home using a standard tin of paint and brush? Save annoying drips and flicks around the tin, and do away with needing to brush the excess paint off the edge, by simply attaching a thick elastic band around the tin. This allows you to wipe the excess away, keep the tin rim clean of paint, and save yourself a lot of bother!

    Read more →
  • Pro Tips Use a walnut to touch up damaged furniture

    Use a walnut to touch up damaged furniture

    Are your wooden chairs and table legs the victim of years of wear and tear, and showing the scars to prove it? Touch up scrapes and scratches, with nothing more than a walnut. By depositing a thin layer of walnut oil (in fact, many oils will work, such as linseed oil), it helps restore the natural colours.

    Read more →
  • Food & Drink Chill white wine without ice

    Chill white wine without ice

    Want to enjoy a nice, cold glass of Chablis – but some fool forgot to chill the wine? There’s always the option of ice though, but melted ice = a watered down glass of wine. Why not use this fantastic life trick: Simply keep a small stock of frozen, white grapes in your freezer. Pop a few in to your wine, and voila – it chills the wine, it doesn’t water it down, and looks fantastic!

    Read more →
  • Pro Tips Save your fingernails when adding to a keyring

    Save your fingernails when adding to a keyring

    We all know how risky it is, trying to add a new key to your keyring. Those metal hoops, insanely close together and often the cause of a cracked nail, need not be a problem! Simply use a staple remover to bite into it, allowing you to thread your new key on without pain or issue!

    Read more →
  • How To How to quickly undo most knots

    How to quickly undo most knots

    The simple knot – such a lifesaver and used throughout the home. But undoing them, especially if the knot has tightened after supporting weight, can be difficult. Solution? Simply twist the loose end as much as possible, until it’s solid. Then push this through the knot, and with a bit of luck – voila! Undone knot.  

    Read more →